DeWalt D51856 Traducido De Las Instrucciones Originales página 27

• Lock the nail pusher (j) in the back position.
• Select appropriate collated nail sticks.
See Technical data.
• Insert collated nail sticks into the loading slot on
top of the magazine.
• Unlatch the nail pusher by pulling rearward and
carefully slide the nail pusher forward to press
against the nails.
Actuating the Tool (fi g. 1)
The nailer operates in sequential action mode.
SEQUENTIAL ACTION MODE
The sequential action mode is used for intermittent
nailing when very careful and accurate placement of
the nail is desired.
• Push the contact trip (d) against the work
surface.
• Pull the trigger (a) to actuate the tool. Each
trigger pull with the contact trip pushed against
the work surface will drive one nail.
WARNING: To reduce the risk of
serious injury, DO NOT depress
trigger when the tool is not in use.
ALWAYS place the tool on a 90° angle
to the workpiece surface.
The removable protective cover (e) protects the
workpiece from damage when working.
Depth Setting (fi g. 1)
WARNING: To reduce risk of serious
injury from accidental actuation when
attempting to adjust depth, ALWAYS:
• Disconnect air supply.
• Avoid contact with trigger during
adjustments.
The depth that the nails are driven can be adjusted
using the depth adjustment on the nosepiece of the
tool.
To reduce the depth, turn the depth adjustment
wheel (f) clockwise (tool pointed away from you).
To increase the depth, turn the depth adjustment
wheel (f) counterclockwise (tool pointed away from
you).
Clearing a Jammed Nail (fi g. 3)
If a nail becomes jammed in the nosepiece,
follow these instructions to remove the nail:
• Disconnect the airline from the tool.
• Remove magazine from nailer body.
– Remove the magazine bolts (k) from both
sides of the magazine.
– Remove the bracket bolt (l).
• Remove the bent nail, using pliers if necessary.
• Reattach magazine.
• Connect the air hose to the fitting on the tool.
• Load nails into the magazine. See Loading the
tool.
WARNING: If nails become jammed
in the nosepiece frequently, have the
tool serviced by an authorised D
service centre.
MAINTENANCE
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from air supply before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. An
accidental start-up can cause injury.
Perform the following maintenance
operations every day:
Lubrication
Lubricate tool with 10-15 drops of D
pneumatic tool oil
Insert drops into the air fitting on the end cap of the
tool.
Drain all condensation from the air
compressor tanks and hoses
• Open petcocks or other drain valves on the
compressor tanks.
• Allow any accumulated water to drain from
hoses.
EN GL IS H
WALT
E
WALT
E
25