Black and Decker GL651 Manual De Instrucciones página 5

Never attempt to remove or replace any parts other than

those specified in this manual.
Electrical safety
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
Additional safety instructions for grass trimmers
The following warning symbols are found on the tool:
Read the manual prior to operation.
Wear safety glasses or goggles when operating this
tool.
Keep people and animals at least 6 m away from the
cutting area.
Do not expose the tool to rain or high humidity.
Be familiar with the controls and the proper use of the tool.

Only use the tool in daylight or good artificial light.

Before use, check the power supply cord and extension

cord for signs of damage, ageing and wear. If a cord
becomes damaged during use, disconnect the cord from
the mains supply immediately. DO NOT TOUCH THE
CORD BEFORE DISCONNECTING THE SUPPLY.
Do not use the tool if the cords are damaged or worn.

Wear stout shoes or boots to protect your feet.

Wear long trousers to protect your legs.

Before using the tool, check that your cutting path is free

from sticks, stones, wire and any other obstacles.
Only use the tool in the upright position, with the cutting

line near the ground. Never switch the tool on in any other
position.
Move slowly when using the tool. Be aware that freshly cut

grass is damp and slippery.
Do not work on steep slopes. Work across the face of

slopes, not up and down.
Never cross gravel paths or roads while the tool is running.

Never touch the cutting line while the tool is running.

Do not put the tool down until the cutting line has come to

a complete standstill.
Use only the appropriate type of cutting line. Never use

metal cutting line or fishing line.
Be careful not to touch the line trimming blade.

Take care to keep the mains cable away from the cutting

line. Always be aware of the position of the cable.
Keep hands and feet away from the cutting line at all

times, especially when switching on the motor.
Warning! The cutting elements continue to rotate after the

tool is switched off.
Never operate the tool with damaged guards or without

guards in place.
Always ensure that the ventilation slots are kept clear of

debris.
Features
This tool includes some or all of the following features.
1. Trigger lever (on/off switch)
2. Handle
3. Cable restraint
4. Power inlet
5. Secondary handle
6. Adjustment button
7. Cable storage hooks
8. Motor housing
9. Guard
10. Line trimming blade
11. Spool housing
12. Cutting line
13. Edge guide
14. Tube
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fitting the guard (fig. A)
Remove the screw (15) from the guard (9).

Place the guard onto the tool as shown.

Firmly press the guard until it snaps into place.

Secure the guard with the screw.

Warning! Never use the tool unless the guard is properly fitted.
Connecting the tool to the mains (fig. B)
Connect the female plug of a suitable extension cable to

the power inlet (4).
Loop the cable through the cable restraint (3).

Insert the mains plug into a mains outlet.

For wired in cable units: Make sure the cable is looped
through the cable restraint prior to connecting the plug to
the mains outlet.
Warning! The extension cable must be suitable for outdoor use.
Setting the tool to the working position (fig. C)
The tool is supplied in a shipping position. The tool must be
set to a working position before use.
ENGLISH
5