Morphy Richards 41540 Manual De Instrucciones página 5

41540 Orbit MEE-Rev2
D D r r y y i i r r o o n n i i n n g g
You do not need to fill the iron with water.
Set the steam control to off.
• Any temperature setting may be used
depending on the garment.
S S t t e e a a m m i i r r o o n n i i n n g g
Turn the temperature control dial to the
steam position and rest the iron on its heel
whilst it warms up.
Turn the steam control to the steam
position C.
• The steam facility should only be used on
garments which are suitable for ironing at
the 3 dot settings.
S S u u r r g g e e - - o o f f - - - - s s t t e e a a m m
Push in the surge button ‡ to obtain a
boost of extra steam for ironing out creases
in heavy material such as denim etc. D.
• The surge-of-steam can be used whilst
dry ironing, providing there is water in the
tank, and the temperature control is set
within the steam range.
• Do not use surge-of-steam at
temperatures below the steam range
shown on the control dial.
• For optimum steam quality, do not operate
the shot more than three times in
succession.
V V e e r r t t i i c c a a l l s s t t e e a a m m
Hold the iron in a vertical position between
1cm and 2cm away from the item. Push the
surge button.
• This feature is especially useful for
removing creases from hanging clothes,
curtains, wall hangings, etc.
E E m m p p t t y y i i n n g g a a n n d d s s t t o o r r i i n n g g
When you have finished ironing, unplug
the iron and allow to cool. Ensure that the
steam control is set to the 'off' position.
Remove the water inlet cover and empty any
30/3/06 9:46 am
remaining water out of the filling hole.
Replace the water inlet cover.
Ensure the iron is cool and thoroughly dry
before storing in the bag provided.
IMPORTANT: The flex can be damaged if
wound too tightly around the iron after use.
Make a loose loop with the flex and wrap it
around the iron. The iron must be cool before
winding the flex and storing on its heel.
Jet cleaning
Your iron has a built-in cleaning system
designed to keep the water valve, steam
chamber and steam vents clear of lint and
loose mineral deposits. Jet clean should be
used after each period of ironing.
1 Ensuring that there is a little water in the
tank, place the iron on its heel and turn
the temperature control dial to the 3-dot
setting.
2 Wait for the temperature indicator light to
go out, then unplug the iron and hold it
about 6" (150mm) above the sink in the
ironing position.
3 Press the surge button about 10 times in
succession.
4 Empty out any remaining water.
IMPORTANT : Do not use descaling
products in this iron.
To clean a coated soleplate
In the unlikely event of any man-made
fibres fusing to the soleplate, set the iron at
the 3-dot position and pass it over a clean
piece of cotton which will draw the deposit
off the surface.
Do not use scouring powder or solution as
this could cause damage to the coating.
To clean the exterior
Allow the iron to cool and wipe with a
damp cloth, then dry.
I I f f y y o o u u r r i i r r o o n n d d o o e e s s n n ' ' t t w w o o r r k k
If the iron does not work, check the
following:
• Has the temperature control been set to
the required temperature?
Page 5
g
5