NORTH STATES 5050 Manual De Instrucciones página 4

Step 4
the gate frame by reinserting the screws. (4a~4b)
4a
Step 5
Do not mount hardware into sheet rock
or plaster. Hardware is included for use
in solid materials only such as wood
or metal.
Hold template (L) against the surface
side). Ensure the template is vertical,
completely outstretched and that the
Mark the screw hole positions.
Step 6
Disconnect both the upper and lower
hinges by sliding the top portion of the
hinge apart. Secure the lower part of
the hinges with the mounting screws.
Ensure the pin is pointing upwards as
shown.
Note:
Do not slide the top portion of the
hinge back on at this time.
Step 7
Hold template (R) against the surface
(latch side).
4b
5
90°
6
7
Page 4
90°