Setting The Speed - Parkside PHKS 1400 Instrucciones Para El Manejo

HANDLING THE CIRCULAR SAW
1. Switch on the motor as described in the section "On/off switch" and then set the front edge of the guide plate
2. Align the circular saw with the parallel guide or with a drawn cutting line.
3. Hold the circular saw with both hands on the handles and saw using moderate force.

SETTING THE SPEED

Using the following advisory settings as a guide, set the rpm on the electronic control wheel to an appropriate value. Turn the wheel
until the required rpm setting is opposite the arrow marking ( ).
(1 = lowest rpm to 4 = highest rpm):
Material
Hard- and softwoods (natural wood) with & across grain
Chipboard, hardboard
Chipboard
Veneered plywood, plywood
Coated and veneered board
PVC board
Acrylic sheet, Plexiglas
Aluminium sheet
Aluminium sections
Plasterboard
Rock wool board
Cement bound woodwool board
FITTING/REMOVAL AND SETTING OF THE REAMER
Caution: The distance between the reamer and the saw blade is not to be more than 5 mm. If the reamer is removed e.g. for plunging
then this distance must be reset.
Fitting/removal of the reamer ( ):
1. Release the wing nut on the depth stop and swing the saw to meet the stop. This reveals the fastening screw for the reamer and loosens it.
2. Screw out the fastening screw and remove the reamer.
CAUTION / IMPORTANT: After plunging, the reamer must be refitted before further use.
Setting the reamer ( ):
The distance between the reamer and the saw blade teeth is to be set to 5 mm max. and the gap between reamer and the deepest point
of the saw blade is to be set to 5 mm max.
1
Thickness
to max. depth of cut
5 - 20 mm
greater than 20 mm
2 - 20 mm
to max. depth of cut
up to 30 mm
up to 25 mm
2 - 12 mm
1.5 - 3 mm
all thicknesses
all thicknesses
up to 20 mm
10
down on the material.
rpm setting
4
3-4
4
3
4
2
2-3
2-3
2-3
1-2
1
1