Description Of The Appliance; Putting Into Operation; Filling The Tank - Air-O-Swiss AOS E2241 Manual De Instrucciones

Description of the appliance

Unpacking
• Carefully remove the humidifier from the box.
• Remove the Ionic Silver Stick
Cable storage (Fig.11)
from the red bag. Section «Water purification» provides
en
information on usage.
Air outlet
• Remove the plastic bag from the humidifier.
• Observe the information given on the rating plate
Control panel
about the mains supply.
• Use the original packaging for storing the appliance if
you do not use the humidifier all year round.
Air inlet

Putting into operation

Main body
• Place the humidifier on the floor on a flat, dry surface
Handle in the room.
• Ensure that there is good access to the humidifier
and that there is sufficient space for maintaining and
cleaning the appliance.
Water tank • For increased evaporation performance in large
rooms, place the humidifier near a radiator (do not
exceed max. temperature of 50 °C).
• Place the water tray in its place in the main body
Sealing ring
and insert the evaporating mat in the water tray as
shown (10).
• Pass the cable through the slot in the lower corner of
Evaporating mat the cable compartment (11). Any excess cable length
can be stowed away in the cable storage.
• Place the housing on the main body (12). Make sure
Water tank cap
that the mat fits in the housing and is not squashed.
• Read the instructions under «Filling the Tank» for
Ionic Silver Stick
®
putting water in the evaporator.
• Insert the plug into the socket and switch on the
appliance using the on/off switch (18).
Water base
• Make sure that the cable is not pinched anywhere
(8 – 9). Do not operate the humidifier if the cable is
damaged (2).
Main body
18
10
(Water purification)
®
11
12

Filling the tank

13
Always unplug the unit before removing the
water tank. Do not operate the humidifier when
the water tank is empty!
• Make sure that no foreign objects are in the water
tank.
• Take off the water tank cap to fill the tank with water
(13). Fill the tank with clean, cold water from the tap
(14). Close the cap of the water tank securely (15),
place the water tank on the base (16). Attention: before
turning round the tank and placing on the main body
make sure that the cover is properly closed!
15
• Carry the tank by holding it by the handle and support
from below with your other hand.
• Do not add any conditioners to the water (17).
• Insert the plug into the socket and switch on the
appliance using the on/off switch (18). The green light
comes on.
• Attention: never pour water into the air inlet or the air
outlet apertures!
• As soon as the tank is in the right position, water flows
from the tank into the water tray.
• Do not move or tip the appliance while it contains
water. Should you have to move it nevertheless, first
unplug and remove the water tank.
17
14
Open
16
Closed
18
en
19