Replacing Accessories; Selecting Sandpaper; Fitting And Replacing Sandpaper; Sanding - JCB -18MT Instrucciones De Funcionamiento

Replacing Accessories

Place the tool on a stable surface, for
m
example a work bench.
Turn the accessory lock forward 180
m
degrees to release the accessory and the
accessory adaptor.
Select the appropriate accessory for the job.
m
Align the mounting holes on the accessory
over the pins on the multi-function head.
Hold the accessory adaptor and accessory
m
against the multi-function head. Release the
accessory lock.

Selecting Sandpaper

NOTE
Work with moderate pressure on the tool
when sanding, otherwise it is easy to mark
the workpiece.
There is a number on the back of the
sandpaper. The higher the number, the smaller
the grit, and the lower the number, the larger
the grit.
Large grit remove more material and
m
are suitable for removing paint or rough
sanding of raw surfaces with burrs and
nicks etc. The sanded surface will be
relatively rough.
Sandpaper with medium grit is often
m
suitable for sanding more simple wooden
structures and carpentry.
Sandpaper with fine grit is suitable for
m
sanding untreated wood when a soft and
smooth surface is required.
14
Sandpaper with extra fine grit is suitable for
m
fine sanding and polishing, or for sanding
between coats of varnish.

Fitting and Replacing Sandpaper

Align the sandpaper to the Velcro fastener
m
on the sanding pad, and press in place.
When replacing or adjusting the position of
m
the sandpaper, pull the sandpaper carefully
off from one of the corners.

Sanding

WARNING!
Sanding dust hazardous to health is produced
from both wood and metal. Wear a dust
filter mask and safety glasses.
NOTE
Always test sand a sample piece first.
Hold the sanding pad just over the
m
workpiece, without the sandpaper
touching the workpiece. Start the multi-
tool and move the power switch to
position 1, and wait until the tool has
reached full power.
Bring the tool down flush with the
m
workpiece, so that all the sanding surface is
in contact with the workpiece.
Do not overload the tool. The tool
m
does the job better and safer when used
at the rate for which it was designed.
Do not angle the tool to sand with
m
only one edge as this can damage
the sanding pad prevent the
sandpaper fastening properly.
Instruction & User Manual
JCB-18MT