JCB -18MT Instrucciones De Funcionamiento página 17

Intended Use
Multi-function tool for a variety of different DIY
jobs, such as drilling, sanding, sawing, screw
driving and cutting.
The tool must not be modified or used for
any other purposes than the ones described in
these instructions.
Battery
NOTE
Make sure the power switch is not pressed
in when inserting or replacing the battery.
Do not force the battery when
m
connecting it, use moderate pressure.
An incorrectly connected battery can
damage the battery terminals or the battery
socket on the tool.
Use the "Press" button on the battery
m
to check the charging status; 4 red LEDs
indicates fully charged, where 1 indicates
low battery status.
Charging The Battery
After charging for the first time, use the tool
m
until the battery is completely discharged.
Repeat this charging and discharging cycle 4
m
to 5 times.
If the LEDs on the charger do not come on
when charging:
Check that the charger's mains adaptor is
m
properly plugged into the power point and
that the charger is switched on
Check that the battery is correctly inserted
m
in the charger
16
Place the battery charger on a level and
m
stable surface. Plug the charger into a 230 V
power point.
Connect the battery to the charger so that
m
it clicks into place. The red LED lights up on
the charger when correct contact is made.
When the battery is fully charged, after
m
about 45 minutes, the red LED goes off and
only the green LED stays on.
Unplug the charger from the power point
m
and remove the battery from the charger.
Connecting the battery
Connect the battery to the battery socket
m
on the tool so that it clicks into place.
Removing the battery
Press the battery lock and remove the
m
battery from the tool.
Instruction & User Manual
JCB-18MT