Publicidad
is hot . Note that the surface remains warm
for several minutes after use.
- Always leave the iron on its stand ( 2 ).
- The iron should be disconnected in the fol-
lowing circumstances :
- Immediately after use.
- Before cleaning or maintenance.
- If it's not working properly .
- If you want to move or manipulate it.
- Never pull the cord to unplug the appliance.
- Your MAXIVAPORE PLUS is designed to
be used by adults. It's not recommended
for use by people with physical, sensory, or
lack of experience, unless they have been
instructed in its use by a person responsi-
ble for their safety .
- This appliance is not a toy, do not let at
reach of children .
- CAUTION: Do not submerge the device in
liquid.
- Never use the appliance in the following
circumstances :
- If the unit has been hit by fall.
- If the unit is leaking water.
- If the power cord is damaged; it must
be replaced by a qualified technician
or service personnel. Never handle it
yourself.
- MAXIVAPORE PLUS has been designed for
domestic use only , any misuse or do not
follow the instructions of this manual voids
the warranty.
Features
- Power supply: 230V -50Hz
- Maximum Power: 2600W
- Water tank capacity : 800ml
Description
1: Base water tank
2: Support insulating
3: steam control button
4: Continuous steam button
5 : Thermostat Button
6: Heat Indicator Light
7: Water tank cap
8: Steam indicator light
9: Steam ejectors
10: Power cable base
11: Power cord of the iron
12: Glass Dispenser
13 : Funnel
Manual MaxiVapore Plus.indd 4
Instructions for use
• Filling the tank :
- Check that the device is not plugged in be-
fore filling the tank.
- Turn the filler cap ( 7 ) in counter-clockwise
and remove it.
- Fill the tank with water to the MAX indicated
on the side of the tank. Use water with no
additives or perfume. If your local supply
has high levels of lime, use distilled water.
Note that failures caused by lime supply
are not covered by warranty.
- Close the cap by turning it clockwise.
• Selecting the ironing temperature and
commissioning:
- Set the desired temperature by turning the
thermostat knob ( 5 ) until the indicator light
turns heat ( 6 ) , following the indicator of
tissue types .
Symbol of the garment Indication
- Connect the equipment.
- Adjust the level of steam ( 9 ) between 0
and MAX depending on the desired intensity
(steam or dry ) .
- The iron base will begin to heat . The steam
light (8 ) and (6 ) heat indicator light will il-
luminate indicating that it has reached the
maximum operating temperature .
Do not iron
Synthetic fabric,
nylon or silk
Wool
Cotton, flax
13/09/13 14:33
Publicidad
