Installing And Removing The Battery Pack - Craftsman Quickwind 20V Max Manual De Instrucciones

English
remove the battery pack before making any
adjustments or removing/installing attachments
or accessories, when replacing line, or prior to
cleaning. An accidental start-up can cause injury.

WARNING:
Always use proper eye
protection that conforms to ANSI Z87.1 (CAN/CSA
Z94.3) while operating this appliance.

CAUTION:
Before you begin trimming, only
use the appropriate type of cutting line.

CAUTION:
Inspect area to be trimmed and
remove any wire, cord, or string-like objects which
could become entangled in the rotating line or spool.
Be particularly careful to avoid any wire which might
be bent outwardly into the path of the appliance, such
as barbs at the base of a chain link fence.

Installing and Removing the Battery Pack

(Fig. G)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack 12 into the tool handle, align the
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button 13 and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. G
12
Proper Hand Position (Fig. H)

WARNING:
To reduce the risk of serious
personal injury, ALWAYS use proper hand position
as shown.

WARNING:
To reduce the risk of serious
personal injury, ALWAYS hold securely in anticipation of
a sudden reaction.
Proper hand position requires one hand on the main
handle 14 and one hand on the auxiliary handle
8
All manuals and user guides at all-guides.com
Fig. H
Switching Trimmer On and Off (Fig. A)
To turn the appliance on, squeeze the lock-off lever
then the variable speed trigger
you may release the lock off lever. To turn the appliance off,
release the variable speed trigger.

Speed Control Switch (Fig. A)
This string trimmer gives you the choice to operate at a
more efficient speed to extend the runtime for larger jobs, or
accelerate the trimmer speed for high- performance cutting.
To extend runtime, pull the speed control switch back
toward the battery housing
mode is best for larger projects that require more time
to complete.
13
To accelerate the trimmer, push the speed control
switch
"HI" position. This mode is best to cut through heavier
growth and for applications that need higher RPM.
nOTE: When in "HI" mode, runtime will be decreased as
compared to when trimmer is in "LO" mode.
Trimming (Fig. I, J)
With the trimmer on, angle it and swing side to side as
shown in Figure I.
Maintain a minimum distance of 24" (610 mm) between the
guard and your feet as shown in Figure J.
4 .
4
1 . Once the unit is running,
WARNING:
Never attempt to lock the
variable speed trigger in the on position.
into the "LO" position. This
11
forward toward the auxillary handle
3
14
2 and
into the
4