Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 28
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
labels on tool
:
The following symbols are shown on the tool:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Additional safety instructions for batteries and
chargers
Batteries
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not store in locations where the temperature may
u
exceed 40 °C.
Charge only at ambient temperatures between 10 °C and
u
40 °C.
Charge only using the charger provided with the tool.
u
When disposing of batteries, follow the instructions given
u
in the section "Protecting the environment".
Chargers
Use your BLACK+DECKER charger only to charge the
u
battery in the tool with which it was supplied. Other batter-
ies could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
u
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
$
Do not probe the charger.
u
The charger is intended for indoor use only.
+
w
Read the instruction manual before use.
Fail safe isolating transformer. The mains
supply is electrically separated from the
transformer output.
(Original instructions)
x
The charger automatically shuts off if the ambient
temperature becomes too high. As a conse-
quence the charger will be inoperable. The unit
must be disconnected from the mains supply and
taken to an authorised service centre for repair.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the charger
unit with a regular mains plug.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Warning! Never attempt to replace the charger unit with
a regular mains plug.
Features
This tool includes some or all of the following features.
1. On/off switch
2. Forward/reverse button.
3. Bit holder
4. LED light
5. Magnetic bit storage
Fig. A
6. Charger
7. Charger plug
8. Charger connector
Assembly
Fitting and removing a drill bit or a screwdriver bit
(fig. B)
This tool uses screwdriver bits and drill bits with a 6.35 mm
(1/4") hexagonal shank.
To fit a bit, insert the bit shaft into the bit holder (3).
u
To remove a bit, pull the bit shaft out of the bit holder (3).
u
note: The right angled attachment shown in fig. E-J may not
be included with your tool.
Use
Warning! Let the tool work at its own pace. Do not overload.
Before first use, the battery must be charged for at least
u
15 hours.
EnGlISH
7

Publicidad

Tabla de contenido
loading

Tabla de contenido