Cosatto NITTY GRITTY CHA CHA Manual Del Usuario página 5

7 - fitting the softgoods
To fit the footmuff unfasten the harness and remove the chest pads and headhugger by unclipping
the shoulder straps from the buckle and sliding off the chest pads and headhugger (a).
Pass the harness straps through the slots in the footmuff and seat liner (b, c & d).
Attach the fabric fasteners (e) at the top of the footmuff to the back of the seat.
Slide the headhugger and chest pads back onto the shoulder straps and re-fasten the buckle.
8 - using the backrest
The backrest can be adjusted in four different positions. To lower the backrest, simply lift the
lever behind the backrest (a). The backrest will drop down automatically. To raise, push the
backrest upwards from the centre to the required angle: it will lock into place automatically.
9 - fitting and using the bumper bar
WARNING: The bumper bar is not a restraint system. Always use
the harness to restrain your child.
To fit the bumper bar push the arms into the slots on each chassis hinge (a) until a 'Click' is heard.
To remove the bumper bar push the buttons on the side of each chassis hinge (b) then pull the
arms out of the slots (c).
To gain access to the pushchair to load or unload your child release one of the bumper bar arms
then rotate the bumper bar (d) and place it to the side of the pushchair (e).
Note: The pushchair can be folded for storage with the bumper bar
in place.
10 - using the calf support
To lower, lift both the levers (on lower part) forward whilst simultaneously pushing the calf support
downward. To raise, just pull the calf support upward and it will automatically lock into place.
11 - removing the basket
Your basket is removable for easier cleaning. To remove your basket, undo the four straps, two
either side. To re-fit your basket, simply reverse the above process. Maximum load 2kg of goods,
evenly distributed.
12 - fitting the hood
To fit the hood, place the back behind the seat (a), clip the brackets into the mountings on the
chassis tubes (b) and push down as shown until they lock in place. Attach the fabric fastener loops
on either side of the hood to the front leg tubing (c).
Attach the fabric fastener tabs to the seat on each side (d). Fabric fastener tabs at the bottom of
the hood attach to the back of the seat when the backrest is in its lowest position.
To remove the hood release the fabric fastener tabs and loops, press the levers under the hood
mountings (e) then lift the hood clear.
13 - using the hood - 1
To raise the hood, pull the top of the hood forward (a) until it locks in position.
To lower the hood, simply push the hood back (b).
To extend the hood, unfasten the zip (c) around the rear frame of the hood then pull the front of
the hood forward (d). To close the extension, push the front of the hood back and refasten the zip.
There is a flap on the rear of the hood that covers a viewing window.
To raise the flap lift it from the bottom (e) then roll the flap towards the top of the hood (f).
Magnets inside the fabric will retain the rolled flap in place.
Unroll the flap to close the window.