Use And Operation - CAPITAL SPORTS Pacemaker X55 Manual De Instrucciones

Getting Started
Power the treadmill on by plugging it into an appropriate wall outlet, then turn on the power switch
located at the front of the treadmill below the motor shield. Ensure that the safety key is installed, as
the treadmill will not power on without it. When the power is turned on, all the lights on the display will
light for a short time.
Self-Checking
When using for the first time, it is necessary to make the machine carry on self-check: Remove the sa-
fety key, press MODE and hold, then insert the safety key again, the machine enters into self-checking
state. During this state, pressing START/STOP can terminate the self-checking.
Quick-Start Operation
1. Press and release the START/STOP to wake display up (if not already on). Note: Installing the safety
key will also wake up the console.
2. Press and release the START/STOP to begin belt movement, at 1.0 km/h, then adjust to the desired
speed using the '+' or '-' . You may also use the rapid speed keys (3, 6 and 9) to adjust the speed.
You can also use '+' or '-'to adjust the speed on handrail.
3. To slow the treadmill down, press and hold the '-' key to desired speed. You may also press the rapid
speed adjust keys: 3, 6, 9.
4. In a state of running, single press START/STOP, the walking belt will gradually slow down if the speed
is above 3.6km/h, if under 3.6km/h, then it will stop immediately.
5. In the state of running, single press CLEAR will reset all number except the speed. Then enter into
manual mode.
6. To stop the tread-belt press and release the START/STOP.
Incline Feature
Incline may be adjusted anytime after belt movement. Press the 'up' or 'down' to achieve desired level
of effort. Four Quick access key of 3, 6 and 9 are also available to adjust the incline percent. You can
also adjust the incline percent by using the '+' or '-' on handrail. The display will indicate incline percent
as adjustments are made. Incline will remain in its position when display is turned off.
400 Meter Track
The 400 Meters Track will be displayed on the simulation running track. The flashing dot indicates your
progress, but only to show an approximate speed of effort. Once the 400 meter is completed, the buzzer
will sound three times, this feature will begin again.

Use and Operation

15