Treatment Procedure - TriPollar STOP Manual Del Usuario

treatment procedure

OVERVIEW OF THE TRIPOLLAR
The green indicator light (fig 6):
Will show you when the device is ON.
The orange indicator light (fig 6):
Will illuminate once your skin has reached
the optimal temperature in the section you
are treating. Safety mechanism:
The automatic safety mechanism protects
your skin from overheating. Once you
have reached the maximum treatment
temperature, the green light will alternately
go off (while orange indicator light is on)
indicating that the energy source has been
automatically shut down. The device will
automatically turn itself back on when the
temperature has gone down below the
maximum treatment or if you have moved
device to adjacent treatment area where
skin temperature is lower.
COURSE OF TREATMENT
1. Treating the entire face takes approximately 20 minutes. For shorter
treatment times, focus on selected areas of concern. Treatment
times differ for each individual.
2. For optimal clinical results, use your TriPollar
times a week for a period of 6-8 weeks.
3. Make sure you have at least a one day interval between treatments
on the same treatment area.
4. In order to maintain long term results after you have finished the
full course of treatments, it is recommended that you use your
TriPollar STOP device 2-4 times a month or as needed.
® ™
4
® STOP DEVICE
™
green indicator
power
light
button
orange
indicator
light
(fig.6)
STOP device 2-3
® ™
BEFORE TREATMENT
1. Cleanse the area to be treated of all creams and ointments.
2. Plug the Power Supply into an electrical outlet and adjust the power
setting (Low/Medium/High) most comfortable for you. During the
first treatment we recommend using the Low setting and then
adjusting according to your skin's tolerance for following treatments.
3. Stop Preparation Gel must be used throughout treatment. Spread a
thin, even layer over the entire treatment area. Your skin may feel
a warm sensation when the gel is applied.
TREATMENT
1. Turn TriPollar STOP ON by pressing the
® ™
Power Button. Make sure the green indicator
light appears. Gently remove the device from its
protective base.
2. Divide the treatment area to several working
sections that are approximately twice the size of the
device head. Place the device on your skin,
ensuring that all 4 electronic tips are touching the skin
at all times.
3. Start moving the device in very slow circular
motions, slowly heating your skin to the optimal
temperature.
4. Once the orange indicator light illuminates,
continue the same slow circular motions for a few
moments before progressing to the next adjacent
working section.
5. Repeat this technique one section at a time until
the entire treatment area has been warmed.
6. Now go over the entire treatment area in larger sweeping circles for
few minutes to rewarm the entire area without waiting for the orange
indicator light to illuminate. This will maintain optimal temperature and
achieve heat uniformity across treatment area. Once the entire
treatment area is rewarmed you have completed treatment session.
treatment
area
work
areas