Installation Steps - AVS Ventvisor Instrucciones De Instalación

Installation Steps

Remove tape liner from rear flange of visor. Peel back 2" (5 cm)
of tape liner from each end of the lateral flange.
free end
lateral flange
rear
flange
3
Gently press the exposed areas of tape against the surface and verify position. With the visor in its final position, remove the remaining
tape
PRESS
visor
5
cross section of visor in
place
Apply pressure along all flanges to ensure proper adhesion of tape.
6
4 Piece Set
8
NOTE: Actual application may vary slightly from illustrations.
free end
front
flange
tape liner by pulling on free ends.
rubber window channel
chrome or black vinyl trim
The rear visor attaches with the same preparation methods as the front visor.
Repeat Steps 1-8 for opposite side.
Align visor to the previously cleaned surface. The lateral flange will
attach to the chrome or black vinyl trim. Insert the front end flange
between the mirror cap and the front door.
4
Retighten previously loosened screws, and replace plastic mirror
7
Page 2 of 3
cap