On/Off Switch - BaByliss PRO FXSM1E Manual De Instrucciones

ENGLISH
Please carefully read the
safety instructions before
using the appliance.
Adaptor
Vibrations
LpA (dB(A))
CORD/CORDLESS
MASSAGER
FXSM1GE
FEATURES
• Stainless steel housing
• Digital motor
• Dual offset massaging weights
• Flexible coil straps
• Lithium-Ion battery
• High/Low massage settings
• Up to 60 minutes run time
• 90 minutes charging time
• Power adapter
OPERATING INSTRUCTIONS
1. Before using the massager
for the first time, charge
continuously for 2 hours.
Maximum battery capacity will
only be reached after 3 charging
and discharging cycles.
2. Make sure the switch on the
massager is in the OFF position.
Connect the charging jack into
the receptacle on the bottom of
the massager. Plug the adapter
into any electrical outlet (at
the voltage listed on the label
affixed to the adaptor). The
charging indicator will light up
to indicate that charging has
begun. Charging is complete
after 90 minutes.
3. The adapter may become warm
while charging. This is normal.
CA82M
20 m/s²
< 70
4. Preserving the batteries: In
order to maintain the optimum
capacity of the rechargeable
batteries, the massager should
be recharged for 2 hours
approximately every 6 months.
5. Turn the switch to "II" for
high-speed function and "I" for
low-speed function.
6. Make sure the switch is in
the 0/OFF position when the
massager is not operating.
FOR DIRECT PLUG-IN
OPERATION
Make sure massager is off.
Connect charging jack into the
receptacle at the end of massager
and plug the adapter into power
outlet.

ON/OFF SWITCH

To operate, simply slide switch
to low or high-speed position.
To stop operation, set to the OFF
position.
HOW TO USE
1. Be sure to consult with client
before use. DO NOT USE
UNTIL YOU HAVE READ THE
OPERATING INSTRUCTIONS
AND THE SAFETY CAUTIONS.
2. Ensure the massager is charged
and in the OFF position (Marked
"0").
3. Make sure massager is in a
position where the springs
are hanging, and the ON/OFF
switch is facing you.
4. Place massaging hand through
both sets of springs four fingers
first, palm down. Your fingers
should be past the second set of
springs and free to move. Your
palm should be exposed with
the back of your hand tight to
the massager pad.
5. With your free hand turn
massager ON to either
5