Assembly - MTD SMART RG 145 Manual De Instrucciones

English
Before working on the
cutters, remove the
spark-plug connector!
Keep fingers and feet
away from the cut-
ters!
Always switch off the
appliance and
remove the spark
plug connector before
adjusting, cleaning or
checking it.
Caution! Danger of
explosion.
Battery acid/risk of
chemical burns.
Wear protective
gloves.
No fires, sparks,
naked flames or smo-
king.
Old batteries must not
be disposed of with
domestic waste.
Before beginning any
work on this mower,
remove the ignition
key and observe all
information contained
in these instructions.
When getting on and
off, never step on the
cutter deck.
Beware of hot
surface!
Before tipping the device, remove
the battery.
10
If operating with an attached trailer,
do not exceed the following maxi-
mum values:
Max. gradient 14%
Max. support load on the trailer
coupling 25 kg
Max. trailer load
(trailer and load) 180 kg
The unit may be operated with the
attached discharge flap or the
mulch locking part only.
Ensure these symbols mounted on
the mower remain legible.
Replace damaged or illegible
symbols.
Symbols in the operating
instructions
The following symbols are used in
these operating instructions:
Danger
Draws your attention to sources of
potential danger associated with
the task you are undertaking at the
time which constitute a danger to
persons.
Caution
Draws your attention to potential
hazards associated with the task
you are undertaking at the time
which could result in damage to
the mower.
Note
This indicates important informa-
tion and application tips.
Operating instructions for lawn tractors
Location details
Where a position on, or in relation
to, the unit is described (e.g. left,
right), this is always from the per-
spective of the driver, sitting on the
driver seat and facing forward.
Disposal instructions
Dispose of packaging remnants,
old mowers, etc., in accordance
with local regulations.

Assembly

Installing the seat
Seat without adjusting lever:
Figure 1
Seat with adjusting lever:
Figure 2
Installing the steering wheel
Fig. 3
Connect steering wheel (1) to

steering shaft (2).
Put on washers (3) and secure

steering wheel with bolt (4).
Note
Put on washer (3) with curved side
face up.
Insert cover cap (5, depending

on model).
Installing the deflector
(Appliances with side ejector)
Fig. 4a
Remove all screws, washers,

and nuts on the deflector.
Insert the deflector (1), and

secure it with the screws,
washers, and nuts.
Secure the cutter rollers (2) with

the available screws, washers,
and nuts.
Fig. 4b
The deflector and cutter rollers are
now installed.
Press the deflector back slightly,

and remove the securing plate.
The deflector closes automati-
cally.