Publicidad
Idiomas disponibles
Idiomas disponibles
Cylinder
securing wire
Insert in the
small holes
Using the Propane Tank
This appliance requires 20 lbs (9 kg) LP-gas supply cylinder.
(not included). Propane is highly flammable and may
ignite unexpectedly when mixed with air. Follow the safety
instructions below when handling the propane cylinder:
• The cylinder used with this heater must be constructed and
marked in accordance with the Specifications for LP-gas
cylinders of the U.S. Department of Transportation (DOT);
or the Standard for Cylinders, Spheres and Tubes for
Transportation of Dangerous Goods and Commission, CAN/
CSA-B339, as applicable;
• The cylinder used with this heater must be provided with
a listed overfilling prevention device; and provided with a
cylinder connection device compatible with the connection
for the appliance;
• Keeping the ventilation opening(s) of the cylinder enclosure
free and clear from debris;
• Do not store a spare LP-gas cylinder under or near this
appliance;
• Never fill the cylinder beyond 80 percent full;
• Place the dust cap on the cylinder valve outlet whenever
the cylinder is not in use. Only install the type of dust cap
on the cylinder valve that is provided with the cylinder
valve. Other types of caps or plugs may result in leakage of
propane.
m
WARNING!
A dented, rusted or damaged
propane cylinder may be hazardous and should be checked
by your propane supplier. Never use a propane cylinder with a
damaged valve connection.
Connect the Propane Tank
m
WARNING!
Never connect an unregulated
propane cylinder to the heater.
1. Open the tank door and place a cylinder inside the tank.
Fig. 10
Let it sit in securely. Use the securing wire to secure the
gas cylinder, like shown (Fig. 11).
Cylinder
securing wire
Propane
cylinder
Tank door
2. Connect the propane hose connector with the propane
cylinder. Turn clockwise to secure (Fig. 12).
Fig. 12
Propane
hose
3. Close the tank door. Lock the door latch
Leakage Test
All connections of this patio heater have been checked at the
factory for leakage. However, in transportation and handling
some connections may have loosened. It's recommended to
run the leakage test every time before using and after parts
replacement.
m
WARNING!
• Do not use an open flame to check for leakage.
• Do not smoke during testing.
• Do not test indoors.
• A leak check must be performed whenever the propane
cylinder is replaced.
NOTE: Use only the pressure regulator supplied with this patio
hearer. Replace it with those specified by the manufacturer
only.
7
Fig. 11
Propane
hose
connector
Publicidad
