Installing Your Montecarlo In The Car; Fastening Your Child Into The Montecarlo; Side Width Adjustments To The Backrest And Headrest - JANE Montecarlo Manual De Instrucciones

INSTALLING YOUR MONTECARLO IN THE CAR

3 Fastening your child into the MONTECARLO

Put your child in the MONTECARLO seat and make sure that
they are sitting right back, pass the strap over their shoulder
and fasten it (3a). Open the safety catch of the clip turning
the lever (3b). Introduce the shoulder strap into the red clip
on the headrest (3c). Pass the abdominal strap under both
armrests on the booster cushion, the area through where the
strap must pass is once again indicated in red (3d). Finally,
tighten the strap.
To take the child out of the seat, just undo the seat belt and
open the shoulder clasp.
When not in use, DO NOT leave the MONTECARLO loose
inside the car, fasten the belt again or store it in the boot.
When you put your child in the seat again, make sure that
none of the straps is coiled up or out of place.
18

4 Side width adjustments to the backrest and headrest

To adjust the sides of the backrest and headrest, turn the
handle located behind the side of the seat. Turn clockwise to
open them, turn anti-clockwise to close them (4a).