Maintenance And After Sales Service - MSA GAG Serie Manual De Instrucciones

MAINTENANCE AND AFTER SALES SERVICE

Methodically follow the chronological order for disassembling the helmet to
reach the component to change. Reassembly will be done in the reverse order.
A regular small screwdriver and a pair of tongs are required.
RATCHET CRADLE
1
• Carefully undo the front and rear clips from their housing and remove the
cradle.
N.B.: For easy refitting, tighten the rapid adjustment system as much as
possible.
REMOVING THE ASSEMBLY
MESH
Release the mesh at the front at the same time as
the front strap.
Release the mesh at the rear (a)
REAR CONNECTOR
Slightly bend the band and release the first stud
then the second.
18
The helmet absorbs the energy of a violent blast by partially
destroying itself or by deteriorating. Even if this deterioration is not
visible, it is important to replace any helmet that was subject to a
violent shock.
CRADLE
The Safety Company
(a)