Publicidad
Idiomas disponibles
Idiomas disponibles
has a wire bunch adequate for the power absorbed by the appliance and is at least type H05 RN-F.
As in international provisions, before installing the appliance a unipolar device must be
installed with a contacts opening of at least 3mm which must not interrupt the YELLOW-
GREEN earth wire. The device must be installed near the appliance, it must be approved and have
adequate capacity for the absorption of the appliance (see technical features).
The appliance must be connected to the UNIPOTENTIAL system. The connector is situated near
the end of the electric cable and is identified by a label with the symbol shown on figure 9 (pag.5).
By using a safety thermostat for breakdown tensions there must observe what follows:
-
According to the ruling normative law, the leakage of electric power for these kind of
appliances can have a value of 1 mA without limitations for the maximum for each kW of
installed power. Besides, there must take care that all the switches for breakdown found on
the market have a tolerance for the operating tension of less than the 50%; that's why there
must be chosen a suitable switch.
-
Connect only a single appliance for each switch
-
In some cases it is possible that the appliance after long periods of inactivity or in case of a
new installation, switches off during working. Most of the times the main reason is the moist
produced during the isolation. The problem can be easily resolved with a short pre-heating
bypassing the safety thermostat.
ATTENTION! All the parts, protected and sealed by manufacturer may not be regulated by
the installer if not specifically indicated.
Glass ceramic electric cooker (fig. 10 –page 5)
To switch on a plate proceed as follows:
-
Rotate the knob (1) in the desired position; the lamp (2) switches on to indicate that the chosen
plate is on (the chosen zone will become red on the glass ceramic surface). This knob (fig.13
pag.6) is linked to the power regulator, by rotating it the machine switches on. In relation to the
position the plate work in a cycle of switching on and off in order to maintain a constant
radiance temperature. By choosing a bigger area marked on the knob the switching on time
becomes higher than the off one. Between the limit of the maximum area and the indicator the
plate works always at the maximum supplied power.
-
In order to avoid uncontrolled and dangerous rise up of the temperature, the machine is
equipped with an automatic safety thermostat which intervene to a fixed temperature.
Ventilated electric oven (fig. 11 – pag.5)
Before turning on the electric oven, it is necessary to select the type of cooking desired in the
following way:
-
turn the knob (1) into the desired position
INSTRUCTIONS FOR USE
Pag. 36/68
Publicidad
