EMU SHADE PRO Manual Del Usuario página 28

REMOTE CONTROL IR
The LED Lights Kit art.999 is equipped with IR remote control (powered by n.2 AAA batteries), its functions are indicated
below.
Functions of the buttons:
1. ON button.
2. OFF button.
3. HIGH BRIGHTNESS button.
4. MEDIUM BRIGHTNESS button.
5. LOW BRIGHTNESS button.
Brightness adjustment:
It is possible to adjust the brightness, through a continuous scale of
levels, by touching with a finger the left semicircle of the ring
positioned on the lower part of the remote control. The brightness
increases clockwise: the minimum brightness is at the lower end of
the semicircle, the maximum at the upper end.
Light temperature control:
It is possible to adjust the temperature of the light, through a
continuous scale, by touching with a finger the right half circle of the
ring positioned on the lower part of the remote control. The
temperature of the light increases counterclockwise: warm light
corresponds to the upper end of the semicircle, cold light
corresponds to the opposite end.
Coupling receiver / IR remote control
To pair the remote control and the receiver, press button 3 once within 3 seconds after connecting the power plug to
the mains. LED lights will flash 3 times if pairing is successful.
Coupling Kit Lights of more umbrellas
To pair the operation of the light kit of more than one umbrella, after pairing the receiver and the IR remote control of
one umbrella (procedure indicated above), repeat the same procedure for the other umbrellas, using the same IR
remote control of the first umbrella. In this way, a single remote control will remotely manage the functions of
switching on, switching off and modulating the intensity and temperature of the light produced.
Cancel pairing:
Press button 3 5 times within 3 seconds after connecting the power plug to the mains. The LED lights will flash 6
times if the cancellation of the remote control / receiver pairing has been successful.
ATTENTION
Do not touch or press the light temperature and brightness control ring while placing the batteries in the
corresponding compartment. Use the IR remote control only 3 seconds after placing the batteries.
Replace the batteries when the control ring is not touch-sensitive with your finger.
High
brightness
Low
Brightness
BRIGHTNESS
Warm
light
Cold
light
LIGHT
TEMPERATURE
27