ARIETE 578 Manual Del Usuario página 14

EN
Never remove the lid (B) during use or when the goblet is positioned on the motor body: a
safety closing system locks the lid on the goblet. Remove the goblet from the motor body
before lifting the lid to avoid damages to the safety lock.
Never pour hot liquids into the blender. The liquids must be within 50°C and must not exceed
the 800 ml level in the goblet.
Pay attention when removing the cap (A) to add and mix the hot ingredients. Steam may come
out unexpectedly.
Keep the food presser away from blades to avoid damage.
AFTER PROCESSING
1. At the end of a program (crush, smooth, soup...), after 3 minutes downtime, the appliance enters
the stand-by mode: the ON-OFF button (L) will go on with the corresponding flashing red light,
while the other buttons/lights will remain off.
- At this point, to proceed with another use of the appliance, press the ON-OFF button (L) which
flashes (the only light on). The whole panel and the texts on the dial (G) will go on and the "RESET"
function will start flashing.
- Rotate the dial (G) to proceed with the selection of one function, or press the increase/decrease
buttons of time and speed to enter the manual mode.
- Press the ON-OFF button (L) to start the program.
2. At the end of a program, if the goblet (C) is removed from the motor body (E), e.g. for pouring, and
immediately after it is placed back properly, after 3 minutes downtime, the appliance enters the
stand-by mode: the ON-OFF button (L) will go on with the corresponding flashing red light, while
the other buttons/lights will remain off.
- At this point, press the ON-OFF button (L) which flashes (the only light on). The whole panel and
the texts on the dial (G) will go on.
- Press any other button, but NOT the ON-OFF button (L) to restart the appliance. The "RESET"
function will start flashing.
- Rotate the dial (G) to proceed with the selection of one function, or press the increase/decrease
buttons of time and speed to enter the manual mode.
- Press the ON-OFF button (L) to start the program.
DISASSEMBLY OF THE BLENDER
- Unplug the appliance and wait for the blades to stop completely before removing the goblet (C)
from the base.
- To remove the lid (B), remove the goblet (C) from the motor body so that the safety device locks
and the lid can be removed easily without the risk of damaging the lock.
- Pour the contents into a glass.
- 12 -