Tools And Materials; Before You Begin - KALLISTA P70001-00 Guia De Instalacion

Thank You For Choosing Kallista
We appreciate your commitment to Kallista quality. Please take a few
minutes to review this manual before you start installation. If you
encounter any installation or performance problems, please don't
hesitate to contact us. Our phone numbers and website are listed on
the back cover. Thanks again for choosing Kallista.

Tools and Materials

Supply
10" Adjustable
Shut-Off
Wrench
Valve
Tubing Cutter
Wax Seal

Before You Begin

CAUTION: Risk of personal injury or product damage. Handle
with care. The product can break, chip, cause injury, or product
damage if handled carelessly. Get assistance lifting the product
into place.
CAUTION: Risk of hazardous gases. If the new toilet is not
installed immediately, temporarily place a large damp rag in the
closet flange to limit exposure to sewer gases.
Observe all local plumbing and building codes.
Carefully inspect the new toilet for damage.
This product consists of a two-piece toilet with standard lift knob
and toilet seat.
If the existing toilet does not have a supply shut-off valve below
the tank, install one before installing the new toilet.
If the floor or closet flange is not level, the toilet may not be level
after it is installed.
Provide adequate clearance for the toilet lift rod. When raised, the
top of the lift rod reaches 34-1/8" (86.7 cm) above the floor.
1008379-2-A
Tape Sponge
Level
Measure
Plus:
• 5/16" T-Bolts w/ Nuts and Washers
• Putty Knife
• Metal File
• 1/2" Nut Driver/Socket
Safety
• Hacksaw
Glasses
• Screwdriver
2
Pipe Wrench
Kallista