Uline H-4408 Manual De Instrucciones página 5

11. Attach the seat planks. Starting from the top row,
place one seat plank on top of the clips, ensure
the clips are resting under the plank in the outside
channels. (See Figure 21)
Figure 21
Frame
Foot Plank
12. The seat planks should have an 18" overhang on
both ends, measuring from the center of the frame.
Make sure the seat end is square with the foot
planks (should line up corner to side). Repeat for the
remaining seat planks. (See Figure 22)
13. Attach back braces. One back brace for each end.
Inside mount, right hand facing upon assembly.
Using 3/8" bolts and flange nuts. (See Figure 23)
Back Brace
Figure 23
PAGE 5 OF 24
ASSEMBLY CONTINUED
Foot Plank
Foot Plank
Figure 22
14. Row 4 has one riser and row 5 has two risers. Place
clips with the 5/16" bolt and flange nut on the
vertical frame. (See Figure 24)
Clips for
Risers
Figure 24
15. Attach risers to clips.
Underneath the risers,
turn the clips horizontally
so the grooves of the
clip fit securely under
the channel lips.
Tighten with flange nuts.
(See Figures 25-26)
Figure 26
16. Tighten all clips.
Hold 5/16"
Carriage
Down
Clip Bolt
Flange
Nut
Figure 25
Riser
0521 IH-4408