TATRA TIM.2504G.A Manual Del Usuario página 27

2. Remove the grid in the
machine, then
water outlet plastic, make
sure that water is drained.
5. Pour the cleaning fluid recommended by the authorized Frozy service center into the tank.
6. Turn on the machine.
7. The cleaning lasts 3 hours and 20 minutes.
8. Do not stop the machine while cleaning is in progress.
9. Then drain the liquid from the tank.
After this cleaning procedure, clean the ice-making set.
CLEANING THE ICE MAKING SET
1. Open the top cover (see the Figure).
2. Wipe the visible surface in the tank and the cooling
pipes with a soapy cloth.
3. Then wipe them dry.
4. Close the machine's top cover.
CLEANING THE WATER SUPPLY FILTER
1. Power off the machine.
2. Shut off the water supply to the machine.
3. Remove the water filter and carry out maintenance
(the frequency of cartridge replacement may vary
depending on the machine operating time; as a rule, it is
recommended to replace it every 6 months)
4. Then bring the ice maker into operation in accordance
with the installation instructions.
Perform the cleaning procedures in the manual at least
4-5 times per year.
3. When draining water
remove from the tank, reinstall
the water outlet plastic.
Position 1
Position 2
(cleaning)
4. Put the machine in
the cleaning position.
EN
27