Safety Symbols; Safety Instructions - skilsaw SPTA70WT-ST Instrucciones De Funcionamiento

SM 2610042781 12-15.qxp_BM 2610016588 02-11.qxp 1/4/16 7:52 AM Page 2
The definitions below describe the level of severity for each signal word. Please read the manual
!
Read and understand all
instructions. Failure to follow
W RNING
all instructions listed below may result in serious
personal injury.
Fully assemble and tighten all the fasteners
required for this stand. Also remember to
occasionally check the stand and make sure
it is still tight. A loose stand is unstable and
may shift in use and cause serious injury.
Turn tool switch off and disconnect power
before mounting to the stand. Unintended
startup during assembly can cause injury.
You have purchased a Skil SPTA70WT-ST
Folding Table Saw Stand for the SPT70WT
Table Saw. Designed for job site use, this unit
sets up and folds quickly.
Before you assemble this
table saw stand
Sort out and account for all parts to make sure
that you have all necessary materials to
assemble your stand. Do not discard packing
material until all parts are accounted for.

Safety Symbols

and pay attention to these symbols.
This is the safety alert symbol. It is used to alert you to potential personal
injury hazards. Obey all safety messages that follow this symbol to avoid
possible injury or death.
DANGER indicates a hazardous situation which, if not avoided, will result
in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided, will result
in death or serious injury.
CAUTION, used with the safety alert symbol, indicates a hazardous
situation which, if not avoided, will result in minor or moderate injury.

Safety Instructions

Assembly
-2-
Before operating make sure the entire unit is
placed on a solid, flat, level surface. Serious
injury could occur if tool is unstable and tips.
Never stand on tool or its stand or use as
ladder or scaffolding. Serious injury could
occur if the tool is tipped or the cutting tool is
accidentally contacted. Do not store materials on
or near the tool such that it is necessary to stand
on the tool or its stand to reach them.
Use only Skilsaw replacement parts. Any
others may create a hazard.
SPTA70WT-ST Table Saw Stand
Package Contents
DESCRIPTION
Stand
Stand Leg
Bolt
Lock Nut
QTY.
1
4
8
8