Installation Steps - AVS Carflector Bugflector II Instrucciones De Instalación

Installation Steps

Clean mounting surface with alcohol pad.
1
Align Hood Shield center point with center of hood.
3
Press firmly along tape flange to secure hood
shield to vehicle hood.
5
NOTE: Actual application may vary slightly from illustrations.
Peel back 2" of tape liner from back of hood shield at
each end of bottom flange.
2
Press on exposed tape to adhere to hood. Remove
remainder of tape lining by pulling on the free ends.
4
Apply bump ons to surface of hood.
6
Page 2 of 3
top flange
bottom flange