Expand-it APR-03 Manual De Utilización página 30

GB
F D E
WARNING
Improper chain sharpening increases the potential
of kickback.
Failure to replace or repair damaged chain can cause
serious injury.
The saw chain is very sharp, always wear protective
gloves when performing maintenance to the chain.
STORING THE PRUNER ATTACHMENT
Store the pruner attachment in a well ventilated place that is
inaccessible to children. Keep away from corrosive agents
such as garden chemicals and de-icing salts.
To remove the pruner attachment from the power head for
storage:
1. Loosen the knob on the coupler device.
2. Push the button in, then twist the shafts to remove and
separate the power head from the attachment.
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM
Bar and chain running hot
and smoking.
Motor runs, but chain
is not rotating.
I P NL S DK
POSSIBLE CAUSE
1. Check chain tension for
overtight condition.
2. Chain oil tank empty.
1. Chain tension too tight.
2. Check guide bar and chain
assembly.
3. Check guide bar and chain
for damage.
N FIN GR HU CZ RU
English
MAINTENANCE
For storing information: Please refer to the Operator's
Manual of your power head.
ATTACHING THE STORAGE HANGER
See Figure 27.
There are two ways to hang your attachment for storage.
To use the hanger cap (8), push in the button (12) and
■
place the hanger cap over end of the pruner attachment's
shaft (5). Slightly rotate the cap from side to side until the
button locks into place.
The hanger hole (33) in the pruner attachment shaft can
■
be used for hanging purposes as well.
TROUBLESHOOTING
23
RO PL SLO HR TR EST LT
SOLUTION
1. Tension chain. Refer to "Chain Tension"earlier
in this manual.
2. Check oil tank.
1. Retension chain, Refer to "Chain Tension"
earlier in this manual.
2. Refer to "Replacing the Bar and Chain"
earlier in this manual.
3. Inspect guide bar and chain for damage.
LV SK BG