Installation - Klarstein Sjiraz 16 Uno Manual Del Usuario

All manuals and user guides at all-guides.com
This appliance contains the coolant isobutane (R600a), a natural gas which
is environmentally friendly. Although it is fl ammable, it does not damage the
ozone layer and does not increase the greenhouse effect. The use of this coolant
has,however,led to a slight increase in the noise level of the appliance. In addition
to the noise of the compressor,you might be able to hear the coolant fl owing
around the system. This is unavoidable,and does not have any adverse effect on the
performance of the appliance. Care must be taken during the transportation and
setting up of the appliance that no parts of the cooling system are damaged. Leaking
coolant can damage the eyes.
Special notes
• When positioning the unit, make sure that the power cord is not pinched or
damaged.
• Make sure that there are no multiple sockets or power supplies on the back of the
unit.
To avoid contamination of food, please follow the instructions below:
• A prolonged opening of the door can lead to a signifi cant rise in temperature in the
compartments of the appliance.
WARNING
When using, servicing and disposing of the unit, pay attention to the left
symbol on the rear of the unit or on the compressor. This symbol warns
of possible fi res. There are fl ammable substances in the refrigerant lines
and in the compressor. Keep the appliance away from sources of fi re
during use, maintenance and disposal.

INSTALLATION

Note: This appliance is designed to be free standing only, and should not be
recessed or built-in.
• Place your device on a fl oor that is strong enough to support the device when it
is fully loaded. To level your device adjust the leveling legs at the bottom of the
device.
• This appliance is not designed to be installed inside of a cabinet.
• Allow 10 cm of space between the top, the back and sides of the wine unit, which
allows the proper air circulation to cool the compressor and condenser.
• Locate the device away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption.
EN
15