Timer Recording Function; Troubleshooting Guide - i-joy TDT Zeus Manual De Usuario

7.5 Timer Recording Function

(a) It can timer the recording program according to EPG or UI.
(b) It supports at most 8 timers for recording.
(c) It supports cyclical appointment (Everyday, Every Year) and one time booking.
(d) When the timers are conflict, it would show the warming information.
(e) In the standby status, it could start the unit and begin the recording automatically.
When the recording is finished, it would go back to standby status automatically.
(f) Details please refer to 4.3.5 WAKEUP TIMER of this manual.
All manuals and user guides at all-guides.com
29

8. TROUBLESHOOTING GUIDE

Problem Possible cause
No picture, no sound. Your Receiver is not plugged
into the mains.
Your TV is in standby mode.
The SCART connection to the
TV is faulty or loose.
The remote Control does not The Remote Control batteries
operate. have been inserted incorrectly
or are dead.
You are not aiming
Remote Control at the receiver.
You cannot find all the The signal to your aerial may
channels you think should be be weak.
available.
You cannot select all of the Some channels have been
channels and the CH+/- keys selected as favorites and the
do not always work. favorite mode is on.
You cannot access a The parental lock has been
particular channel, even using activated on this channel and
the number keys. an OSD message prompts you
for your PIN code.
Each time you set a timer, the The maturity level
PIN code is requested control is set
The on-screen displays are If you have connected usind
not as sharp as expected. SCART and you have an
RGB-capable TV, one of the
receiver settings
wrong.
You have connected
receiver TV SCART
SCART socket of your TV set
which is not RGB-capable.
The picture on some channels The broadcast is probably in
seems to have been stretched widescreen and the receiver
or squashed. settings may be not correct.
30
Action
Check mains connection and press
the power key on the Remote
Control.
Press either CH+ or CH-, or
STANDBY key on the TV to bring it
out of standby.
Check the TV SCART connection.
Check the batteries and replace if
necessary.
you Make sure you aim the Remote
Control at the receiver and not at the
TV
Try retuning your receiver.
Use the <All channels> key to select
another Favorite list or the default TV
channels list.
Enter your parental code to access
the channel or unlock the channel.
See 4.3.6 section for more details.
access Set the maturity level access control
to None or prefer lock specific
channels.
Refer to 4.3.2 section and modify the
" TV Output signal"setting to RGB.
could be
the Check if the TV SCART socket of the
to a TV is RGB-capable. If not, refer to
the user manual of your TV to
change the SCART connection to
your TV.
Check the receiver " aspect ratio"
option setting, following the
information in 4.3.2. If you have a
widescreen TV, you may also need
to check the settings on your TV.