Installation Steps; Care And Cleaning - AVS Ventvisor Deflector Instrucciones De Instalación

Installation Steps

Remove tape liner from rear flange, then peel 2" (5 cm) of
tape liner from each end of lateral flange.
free end
rear
flange
3
With the visor in its final position, remove remaining tape liner
by pulling on free ends.
5
4 Piece Set
The rear visor attaches with the same
plastic cap
7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
Auto Ventshade
™
NOTE: Actual application may vary slightly from illustrations.
lateral flange
front flange
door
frame
visor
black rubber
window channel
cross section of visor in place
preparation methods as the front.
rear visor in position
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2005 Lund International, Inc. All rights reserved.
, the Auto Ventshade
TM TM
Align the visor with the previously cleaned area. Tuck the
front end flange into the door window channel. The rear end
flange will attach to the outside of the plastic cap.
front flange
into window
free end
channel
4
Apply pressure along all flange edges to ensure adhesion of
6
Repeat Steps 1-7 for the opposite side.
logo and the AVS logo are trademarks of Lund International, Inc.
TM
Page 2 of 2
rear flange
outside plastic
cap
tape liner.