Setup And FI Rst Operation; Unpacking; Check Accessories; Setup - DENTSPLY Multimat 2 Touch Manual De Instrucciones

3 Setup and first operation

3.1 Unpacking

• First, please check the "Shockwatch" label on the carton. If it is colored red, the impact energy during transport was higher than allowed
and your unit could be damaged. Ask the transport agent to confirm the triggering of the "Shockwatch" label in writing.
• Open the packaging and unpack the Multimat2 Touch carefully.
• Prior to setting up, check the unit for visible exterior damage. Do not set up or operate a damaged unit.
Please contact us, if the furnace is damaged.

3.2 Check accessories

• Check the delivery on completeness.
Each Multimat2 Touch is supplied with:
– 1 main power lead
– 1 honeycomb firing goods carrier
– 1 firing socket
– 1 pair of tweezers
– 1 operating manual
Each Multimat2 Touch+Press is additionally supplied with:
– 1 compression socke
– 1 filter control with manometer and compressed air tube
For pressing FAC pressable ceramics, you will furthermore need 3.4.2 Language selection aluminum oxide pistons, embedding paper and
muffle set.
These parts are included in the FAC complete set. Should you require individual parts, you can order these with the numbers
D430112 FAC large muffle set
FAC small muffle set (not available in Germany)
D430114 FAC aluminum oxide piston
D430115 FAC embedding paper
• Please retain the transport package.The supplied package protects the unit from transport damage. If possible, keep the package material,
in case you need to transport the unit later.

3.3 Setup

• Place the furnace on a suitable surface and allow for sufficient distance to walls (min. 25 cm).
• Place the firing socket on the firing socket holder.
• Connect the power plug of the Dentsply vacuum pump with the vacuum pump socket on the furnace and insert the vacuum tube in the
tube connector on the furnace. The arrow on the filter must point into the direction of the vacuum pump.
• If you have a Multimat2 Touch+Press, insert the compressed air tube of the filter pressure control into the compressed-air
connection of the furnace.
• Connect the filter pressure control with the compressed air feed and set the operating pressure of the pressure furnace
to 2.7 bar (the operating pressure of 2.7 bar is set by the manufacturer).

3.4 Initial operation

• Before establishing the power connection, check whether the mains voltage of your power supply corresponds to the mains voltage
specified on the type label of your furnace.
• Connect the power lead with the furnace and with a mains socket. The green power LED above the numeric sensor pad illuminates.

3.4.1 Start screen display

The start screen display showing the Dentsply logo, the version number of the software as well as the serial number of the con-trol unit will ap-
pear on the screen for 6 seconds. The firing chamber with a possibly vacuum will be filled with air. The following screen will appear:
52
All manuals and user guides at all-guides.com