Install The Plaster Guard; Set The Pipe Depth - Jacob Delafon E8014 Instrucciones

• Temporarily install a nipple to each tee/elbow. Do not use any sealant.
• Do not strap the pipes at this time.

2. Install the plaster guard

• Install the plaster guard.
• Push until the plaster guard is snug against the face of the elbow (or tee)

3. Set the pipe depth

NOTE : Thin wall installations have a finished wall thickness of less
than 1/2" (1.3 cm).
• To adjust the pipe depth, use a level or other straight edge to line up the "Thin Wall
Installation" mark with the front face of the studs.
16
All installations
Elbow (or Tee)
Plaster guard
Thin wall installation
Align mark with the front of
the stud face.
English