Installing The Plastic Wedges - Beko GN1416220CX Manual De Instrucciones

3 Installation
3.1 Appropriate location
for installation
Contact an Authorized Service for the installation
of the product. In order to prepare the product
for use, refer the information in the user manual
and ensure that electrical installation and water
installation are appropriate. If not, call a qualified
electrician and technician to have any necessary
arrangements carried out.
B
WARNING:
be held liable for damages that may
arise from procedures carried out by
unauthorized persons.
B
WARNING:
in during installation. Otherwise, there is
the risk of death or serious injury!
WARNING:
room where the product shall be placed is
A
so tight to prevent passing of the product,
remove the door of the room and pass the
product through the door by turning it to
its side; if this does not work, contact the
authorized service.
prevent jolts.
heat sources such as hobs, heater cores and
stoves and at least 5 cm away from electrical
ovens.
and kept in humid places.
around your product in order to achieve an
efficient operation. If the product is to be placed
in a recess in the wall, pay attention to leave at
least 5 cm distance with the ceiling and side
walls.
temperature falls below -5°C.

3.2 Installing the plastic wedges

Plastic wedges supplied with the product are
used to create the distance for the air circulation
between the product and the rear wall.
Manufacturer shall not
Product must not be plugged
: If the door clearance of the
1. To install the wedges, remove the screws on the
product and use the screws supplied together with the
wedges.
2. Insert the 2 plastic wedges onto the rear ventilation
cover as illustrated in the figure.
7 / 27 EN
Refrigerator / User Manual