4
Preparation
4.1 Things to be done for
saving energy
A
Connecting your refrigerator to systems
that save energy is dangerous as they may
cause damage on the product.
Do not leave the doors of your refrigerator open
for a long time.
Do not put hot food or drinks in your
refrigerator.
Do not overload the refrigerator. Cooling
capacity will fall when the air circulation in the
refrigerator is hindered.
Do not place the refrigerator in places subject
to direct sunlight. Install the product at least
30 cm away from heat sources such as hobs,
ovens, heater units and stoves and at least 5
cm away from electrical ovens.
Pay attention to store your food in refrigerator
in closed containers.
To be able store maximum food in the freezer
compartment of your refrigerator, the upper
drawer has to be removed and placed on top
of glass shelf. Power consumption stated for
your refrigerator has been determined after
removing the icematic and the upper drawers
as to allow maximum loading. It is strongly
recommended to use the lower drawers in the
freezer and the multizone compartment while
loading.
Airflow should not be blocked by placing
foods in front of the freezer and the multizone
compartment fans. Foods should be loaded by
leaving minimum 5 cm space in front of the
protective fan grid.
Thawing the frozen foods in the fridge
compartment both saves energy and reserves
the quality of the foods.
Since hot and humid air will not directly
penetrate into your product when the doors are
not opened, your product will optimize itself
in conditions sufficient to protect your food.
In this energy saving function, functions and
components such as compressor, fan, heater,
defrost, lighting, display and so on will operate
according to the needs to consume minimum
energy while maintaining the freshness of your
foodstuff.
C
Temperature of the room where your
refrigerator is located should at least
10ºC /50°F
be
refrigerator under cooler conditions is not
recommended with regard to its efficiency.
C
Inside of your refrigerator must be cleaned
thoroughly.
C
If two coolers are to be installed side
by side, there should be at least 4 cm
distance between them.
4.2 Recommendations about the
fresh food compartment
Make sure that the food does not touch the
temperature sensor in fresh food compartment.
To allow the fresh food compartment to keep
its ideal storage temperature, the sensor must
not be hindered by food.
Do not place hot foods or beverages inside the
product.
10 / 27 EN
. Operating your
Refrigerator / User Manual