Configuring The Bus Coupler - Aventics EtherCAT Instrucciones De Servicio

74 AVENTICS | EtherCAT | R412012792–BDL–001–AB
Commissioning and operation

7.2 Configuring the bus coupler

The configuration steps laid out in this section are
superior to the settings on the bus coupler which have
already been described (see "Making settings" on
page 65) and are a part of the entire system's bus master
configuration.
The work described here may only be carried out by
qualified electronics personnel and in compliance
with the operator's documentation on configuring the
bus master, as well as applicable technical
standards, directives, and safety regulations.
Before starting configuration, the following steps must
have been carried out and completed on the bus coupler:
You have assembled the bus coupler and valve
W
terminals (see "Assembly" on page 57).
You have connected the bus coupler
W
(see "Connecting the bus coupler electrically" on
page 59).
You have carried out the presettings
W
(see "Making settings" on page 65).
Configuration error
An incorrectly configured bus coupler will lead to
malfunctions in the system and may damage the
system.
O The configuration may only be carried out by
qualified electronics personnel!
Configure the bus system in accordance with your
O
system requirements, the manufacturer's
specifications, and all valid technical standards,
directives, and safety regulations. Take the operator's
documentation on configuring the bus master into
account.
NOTICE