Installation Steps; Care And Cleaning - AVS Ventvisor Deflector Instrucciones De Instalación

Installation Steps

Align visor to the previously cleaned surface. The flanges of the visor attach to the surface of the window frame ABOVE the rubber trim
3
Gently press the exposed areas of tape against the surface and
verify position.
4
Apply pressure along all flanges to ensure proper adhesion of tape.
6

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
Auto Ventshade
™
NOTE: Actual application may vary slightly from illustrations.
of the window frame.
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2005 Lund International, Inc. All rights reserved.
, the Auto Ventshade logo and the AVS
TM TM
PRESS
visor
With the visor in its final position, remove the remaining tape liner
5
4 Piece Set
7
Repeat Steps 1-7 for opposite side.
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2
tape
rubber window
white metal trim
door glass
by pulling on free ends.
The rear visor attaches with the same prepa-
ration methods as the front visor.
inside face of
window frame
rubber trim
channel