Mounting The Wddg1 Housing; Mounting The Wddg2 Housing - Eneo VK-1318/WDDG1 Manual De Instrucciones

3. Mounting the WDDG1 Housing

Wall and ceiling mounting
Note
A Screw holes
W Back of housing
Note
G Housing cap
Connection cable
K Cable feed

4. Mounting the WDDG2 Housing

W
G
The operational side of the camera is mounted in the housing.
Prepare the mounting site for installation.
Loosen the 4 Torx screws on the housing, but do not completely remove them,
and remove the cap.
Mark the position of the back of the housing W on the surface on which the
device is to be mounted. The screw holes A in the attached plate and/or on the
back of the housing W may be used as a template.
Fix the back of the housing W on the desired surface (plug and cross-head
screws are enclosed) and feed through the cable. 1/3" or 1/2" opening.
When mounting on a ceiling, the camera must be installed within the housing.
Fasten housing cap G on the back of the housing.
After connecting the power supply and attaching the coaxial cable to an
appropriate monitor, the camera is operational.
Rubber washer for cable feed
K
W
G
Teflon
strip
15
Wall / ceiling
K
A
Wall / ceiling
B