B&G electronics PW-50 Manual De Instalación Y Operación página 2

PW-50 PW-50
V5 V5
COMPONENTS AND RECOMMENDED LOCATIONS IN THE VEHICLE
(1) Electronic unit
(1) Control keyboard & internal microphone
(1) 50W loudspeaker
(2) External microphones
(1) Internal speaker
(1) Keyboard harness
(1) Power cable (battery)
(1) Fuse 10A
(1) Speaker extension cable
(1) Loudspeaker and auxiliary load harness
INSTALLATION AND ELECTRIC DIAGRAM
To install the equipment, see the installation diagram on page 4.
Avoid leaving visible cables in the cabin to maintain the vehicle's aesthetics unaffected.
If there are any cables left disconnected, insulate them with tape; disconnected cables
making an undesired contact can cause a malfunction.
Electronic Unit
Place it on a hidden location for aesthetic purposes. Make sure that the
location allows some ventilation to avoid overheating.
Digital Keyboard
To facilitate handling of the equipment, place the keyboard on a location
within the driver's reach, such as the console of the vehicle. Clean the
surface where the keyboard is to be sticked to ensure an adequate
adherence. Remove the protective liner from the adhesive pad in the back
side and stick it to the surface.
To clean the keyboard, gently wipe it with a dry cloth. Do not use water or
any solvent.
Loudspeaker
When selecting the location for the loudspeaker, keep in mind that this
component is suitable for outdoor use but it is not immersion-proof.
The loudspeaker must be placed as far as possible from the keyboard
(where the internal microphone is located) in order to avoid feedback.
External Microphones
The microphones require an assembly procedure, shown on the next page.
There are two recommended locations to place them, see the installation
instructions on the next page.
Internal Speaker
Locate the speaker out of view, without affecting the sound.
EXTERNAL MICROPHONES INSTALLATION INSTRUCTIONS
Shell
Microphone
Mounting
tape
EXTERNAL MIC
CONTROL KEYPAD
& INTERNAL MIC
PW-50
ELECTRONIC UNIT
50W
LOUDSPEAKER
INTERNAL SPEAKER EXTERNAL MIC
Each microphone includes a shell to hold
it in place and protect it from outdoor.
Depending on the installation procedure,
it can be more convenient to assemble
microphone and shell either before or after
the wiring.
For instance, if the wiring requires to pull
the cable through a narrow space, it is
recommended to assemble after wiring.
2 2 PW-50 PW-50
V5 V5
Microphone + shell assembly procedure
1. Insert the cable in the shell by pressing it with your fi nger.
3. Remove the liner from the tape and stick it to the shell.
Location A
Inside the rearview mirror.
This location offers the highest
sound volume, yet the most
time consuming installation, as
it requires to take parts of the
vehicle apart.
Location B*
In the gap of the front doors.
Select a surface to place the
microphone, so that it faces to
the exterior from inside the gap.
Once the surface is selected,
the installation is fairly easy.
* WARNING!
On location B, place the
microphone slightly
downward to prevent
damage from water clogging.
2. Push the microphone into the shell (do not pull the cable!).
4. Stick the shell on the selected surface, previously cleaned
with a 1:1 solution of isopropyl alcohol in water.
Recommended spots to install the microphones
There are two recommended spots in the vehicle (see
fi gure to the left), they differ with regard to ease of
installation and audio reception volume.
You can select a location according to your preferences.
3 3