Stryker M-1 Manual De Instrucciones página 24

To change the cot height:
1. Pivot the retractable lifting handles (A) into position (Figure 9).
2. Position an operator at the foot end and one at the head end of the cot.
3. Grasp the hand grips on the base unit.
4. Lift the cot up approximately 1/4 in. until the weight is off of the latching mechanism.
5. Squeeze and hold the red release handle to raise or lower the cot to the desired height.
6. Release grip on the release handle to stop the cot in the next available cot position.
A
F F i i g g u u r r e e 9 9 – – P P o o s s i i t t i i o o n n i i n n g g t t h h e e l l i i f f t t i i n n g g h h a a n n d d l l e e s s
E E x x t t e e n n d d i i n n g g o o r r r r e e t t r r a a c c t t i i n n g g t t h h e e r r e e t t r r a a c c t t a a b b l l e e l l i i f f t t i i n n g g h h a a n n d d l l e e s s
N N o o t t e e - - Always make sure that you lock the retractable lifting handles before you lift the product.
To extend or retract the retractable lifting handles (Figure 10):
1. Press the release buttons to pull out or push in the retractable lifting handles.
2. Release the release buttons when the handles lock into the intermediate position.
3. Press the release buttons to pull out or push in the retractable lifting handles again.
4. Release the release buttons when the handles lock into the fully extended or retracted position.
EN 20 6100-109-005 Rev D.1