LUND SR2 Instrucciones De Instalación página 4

(Fig 3) Thread (1) 8mm Hex Bolt
into the nut on the plate. Stop when
bolt reaches end of nut as pictured
(Fig 5) Thread Plastic Retainer onto Bolt
Plate to hold Bole Plate in position.
8mm Flat Washer
8mm Lock Washer
8mm Hex Nut
NOTE: Notch on
Front Bracket
(Fig 7) Attach Bracket to threaded end of Bolt Plate
first. Remove 8mm Hex Bolt (see Fig 3). Rotate Bolt
Plate to line up with remaining factory hex shaped hole.
09-17 DODGE RAM 1500 & 10-17 RAM 25-3500 CREW CAB
Passenger Side Installation Pictured
Plastic Retainer
8mm Hex Bolt
8mm Lock Washer
8mm Flat Washer
Front
Page 3 of 6
(Fig 4) Use the loose Hex Bolt as a handle. Insert
the Bolt Plate into the oval hole and feed the
threaded end out either factory hex shaped hole.
IMPORTANT: Do not let go of the hex bolt until after
Plastic Retainer has been threaded onto bolt (Fig 5)
Front
(Fig 6) Passenger/right side Front Bracket
Plastic Retainer
SR2 RUNNING BOARD
NOTE: Notch on
Front Bracket
11/27/17 (RA)