Brush/Pad-Holder Installation And Removal - Viper AS4325B Instrucciones De Uso

INSTRUCTION FOR USE

BRUSH/PAD-HOLDER INSTALLATION AND REMOVAL

NOTE
Install either the brush (A, Figure 5) or pad-holder (B and C, Figure 5) according to the type of floor to be
cleaned.
CAUTION!
Before installation or removal of brush or pad-holder, make sure all the switches on machine are in off position
and lifting up the squeegee and the brush/pad-holder deck from the floor. The operator must be equipped with
suitable personnel protection devices such as gloves to reduce the risk of accidents.
Proceed as following:
1. Shut off the power switch (39, Figure 2).
2. Lift the deck by pressing the pedal (27, Figure 1).
3. Place the brushes (A, Figure 5) or the pad-holder (B,
Figure 5) under the deck (12, Figure 1).
4. Lower the deck on the brushes/pad-holders by pressing the
pedal (27, Figure 1).
5. Press the start switch (39, Figure 2).
6. Press one of the Brush/forward gear safety switch lever (2,
Figure 1) to engage the brush/pad-holder, then release it. If
necessary, repeat the procedure until the brushes/pad-
holders are engaged.
7. If Step No.6 above proves to be difficult, use the manual
method by turning the brush/pad-holder in the direction
opposite to the normal turning direction, and it can be taken
off. (as shown in Figure 5)
WARNING!
To engage the brush/pad-holder press the safety switch lever (2, Figure 1) which turns on the brush/pad-holder
motor.
8. To remove the brush/pad-holder lift the deck by pressing the pedal (27, Figure 1), then press the switch (37, Figure 2), the brush/pad-
holder will be removed.
A
Figure 5 Figure 5
14
ENGLISH
B
C