Machine Operation (Scrubbing And Drying) - Viper AS4325B Instrucciones De Uso

INSTRUCTION FOR USE
NOTE
To move the machine forward, press either the left or right safety switch lever (J, Figure 8) or both.
7. If necessary, press the handlebar adjusting lever (3, Figure 1) to adjusting the handlebar height.
Stopping the machine
8. Stop the machine by using the handlebar (I).
9. Stop the brushes and the vacuum system by pressing the switch (G). The vacuum system stops after a few seconds.
10. Lift the brush/pad-holder deck(M) and the squeegee (L) by pressing the pedal (K).
11. Make sure that the machine cannot move independently.

MACHINE OPERATION (SCRUBBING AND DRYING)

1. Start the machine as shown in previous paragraphs.
2. While keeping both hands on the handlebar press the safety switch lever (J, Figure 8), then maneuvre the machine and start
scrubbing/drying the floor.
NOTE
For correct scrubbing/drying of floors at the sides of the walls, it is Suggested to go near the walls with the right
side of the machine (A and B, Figure 9) as shown in the figure.
CAUTION!
To avoid any damage to the floor surface, turn off the brushes/pad-holders when the machine stops in one
place.
Battery discharge during operation
While the green warning light (C, Figure 8) stays on, the batteries allow the machine to work normally. When the green warning light
(C) turns off, and the yellow warning light (B) turns on, it is advisable to charge the batteries, because the remaining charge will last for
a few minutes (depending on battery characteristics and work to be performed). When the red warning light (A) turns on, batteries are
fully discharged. After a few seconds, the brush/pad-holder is automatically tuned off.
CAUTION!
Do not use the machine with discharged batteries, to avoid damaging the batteries and reducing the battery
life.
Figure 9
Figure 9
17
ENGLISH
B