Tank Emptying; After Using The Machine - Viper AS4325B Instrucciones De Uso

INSTRUCTION FOR USE

TANK EMPTYING

An automatic float shut-off system (B, Figure 10) blocks the vac-
uum system when the recovery water tank (C) is full. The vacuum
system deactivation is signaled by a sudden increase in the vacuum
system motor noise frequency, also the floor has not dried.
CAUTION!
If the vacuum system turns off accidentally
(for example, when the float is activated be-
cause of a sudden machine movement), to re-
sume the operation: turn off the vacuum sys-
tem by pressing the switch (G, Figure 8), then
open the cover (A, Figure 10) and check that
the float inside the grid (B) has gone down to
the water level. Then close the cover (A) and
turn on the vacuum system by pressing the
switch (G, Figure 8).
When the recovery water tank (C, Figure 10) is full, empty it according to the following procedure.
Recovery water tank emptying
1. Stop the machine.
2. Lift the brush/pad-holder deck (M, Figure 8) and the squeegee (L)
by pressing the pedal (K).
3. Push the machine to the appointed disposal area.
4. Empty the recovery water tank with the hose (N, Figure 8). Then,
rinse the recovery tank (C, Figure 10) with clean water.
5. Remove the recovery tank lid (A, Figure 10) and clean the inside of
the cover and the filter floater grid (B) with clean water.
6. Check the recovery tank (D, Figure 10) whether there is foreign
body jam and clean it.
CAUTION!
When draining the wastewater, the vacuum tube for waste must be folded (C, Figure 11) and lowered to a lower
position (D, Figure 11), and then open the lid of the vacuum tube for waste to drain the water. Do not make
the outlet of the vacuum tube for waste face upward to drain the water vertically. This is to avoid wastewater
spilling onto the operator.
7. Perform steps 1 to 4.
Solution/clean water tank emptying
8. Empty the solution tank with the outlet cover (E, Figure 11). After working, rinse the tank with clean water.

AFTER USING THE MACHINE

After working, before leaving the machine:
1. Remove the brushes/pad-holders.
2. Empty the tanks (A and B, Figure 11) as shown in the previous paragraph.
3. Perform the daily maintenance procedures (see the Maintenance chapter).
4. Store the machine in a clean and dry place, with the brushes/ pad-holders and the squeegee lifted or removed.
C
A
B
Figure 11
Figure 11
18
ENGLISH
A
B
Figure 10
Figure 10
C
D
E
D