Machine Long Inactivity; First Period Of Use; Maintenance; Scheduled Maintenance Table - Viper AS4325B Instrucciones De Uso

INSTRUCTION FOR USE

MACHINE LONG INACTIVITY

If the machine is not going to be used for more than 30 days, proceed as follows:
1. Perform the procedures shown in After Using the machine paragraph.
2. Disconnect the battery connector (B, Figure 3).

FIRST PERIOD OF USE

After the first 8 hours, check the machine fastening and connecting parts for proper tightening and check the visible parts for wear and
leakage.

MAINTENANCE

WARNING!
Maintenance procedures must be performed after the machine is turned off and the battery charger cable
is disconnected. In addition, carefully read the safety chapters in the manual.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel or an authorized Service Center. This
manual only describes the general and common maintenance procedures.

SCHEDULED MAINTENANCE TABLE

CAUTION!
The procedure marked with (1) must be performed when the machine is used after 9 hours for the first time. The
procedure marked with (2) must be done by Service Center that is qualified by our company.
Procedure
Battery charging
Squeegee cleaning
Brush/Pad-holder cleaning
Tank cleaning
Tank sealing strip inspection
Float ball filter cleaning
Squeegee blade check and replacement
Cleaning water filter cleaning
Solution filter cleaning
WET battery fluid level check
Screw and nut tightness inspection
Brush/Pad-holder carbon brush check or replace-
ment
Suction motor carbon brush check or replace-
ment
Daily, after each use
19
Weekly semiannually
(1)
ENGLISH
Yearly
(2)
(2)