Solution Filter Cleaning; Squeegee Cleaning - Viper AS4325B Instrucciones De Uso

INSTRUCTION FOR USE

SOLUTION FILTER CLEANING

1. Pushing the machine on a level floor.
2. Ensure that the machine is off.
3. Emptying the solution tank (Advice).
4. Remove the cover (D, Figure14), then remove the filter strainer (E).
Clean and install them on the support (F).
NOTE
The filter strainer (E) must be correctly posi-
tioned on the housing (H) of the support (F).

SQUEEGEE CLEANING

NOTE
The squeegee must be clean and its blades must be in good conditions in order to get a good drying.
CAUTION!
It is advisable to wear protective gloves when cleaning the squeegee because there may be sharp debris.
1. Push the machine to a level floor.
2. Ensure that the machine is off.
3. Lower the brush/pad-holder deck (M, Figure 8) and the squeegee (L) by lifting the pedal (K).
4. Disconnect the vacuum hose (B, Figure 15) from the squeegee (C).
5. Loosen the knobs (D) and remove the squeegee (E).
6. Clean the steel or the plastic squeegee (E, Figure 15). Clean the compartments (I) and the hole (H) especially. Check the front blade
(F) and the rear blade (G) for integrity, cuts and tears; if necessary replace them (see the procedure in the following paragraph).
7. Assemble the squeegee in the reverse order of disassembly.
F
G
E
D
A B
Figure 15
Figure 15
22
H
E
Figure 14
Figure 14
C D
F G
E
ENGLISH
I
H