Switch-On/Switch-Off; Machine Serial Number Configuration Page - IRTEC smart Manual De Instrucciones

11.2. Switch-on/Switch-off.

The display, for efficient battery saving, switches off after a few minutes from the end of the work cycle or
after 3 hours when no reel movement has been detected.
In this battery saving condition, to start the display, press and hold the external button until the monitor
(located near the display based on the type of machine) turns on.
Pressing and holding the same button for at least 5 seconds fully turns off the device, this operation must
be performed each time the battery needs to be disconnected.

11.3. Machine serial number configuration page.

The machine's serial number can be set by means of the selection wheel/button (only at the first start-up or
following a deletion of the serial number by the operator). The machine's unique identification number is
very important when connecting to the "Digital Irrigation" portal as it establishes the connection address.
Once the serial number has been set, it must be confirmed using the F8 key.
NOTE: if the ID is left at "000000", entry will be required at each restart.
48
90
SMART
20/01/2020