IRTEC smart Manual De Instrucciones página 58

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Display of the command of the device at machine input, in case of presence of the motorised valve
(also combined with the discharge valve) there are 4 icons that represent respectively: the opening
stage (figure 46), the closing stage (figure 45), the valve fully closed (figure 47) and the valve fully open
(figure44).
126
If there is only the discharge valve, then the following icons will be present: on when the discharge
valve is closed (figure 48) and off with the discharge valve open (figure 49) during the STOP stage.
In the last case in which the motor pump is controlled, the icon will be on (figure 51) only during the
shutdown stage, when the machine at the end of the cycle commands the STOP of the motor pump
unit.
ByPass valve control status (machine speed management), via the two -/+ icons that appear
respectively when the opening (figure 52) of the ByPass valve is controlled to reduce speed or closed
(figure 53) to increase the speed of the machine.
If none of the two symbols are visible, this means that the ByPass valve is not controlled at that time.
When present in the machine configuration, the fifth and last icon represents the status of the second
raingun which will be green (figure 54) during operation.
58
125
127
128
131
132
134
124
129
130
133
135
SMART
20/01/2020

Publicidad

Tabla de contenido
loading

Tabla de contenido