Before Starting The Equipment - Toolson PRO-OS 280 E Manual De Instrucciones

All manuals and user guides at all-guides.com
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level ..................... 78.1 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level ....................... 89.1 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 60745.
Vibration emission value a
K uncertainty = 1.5 m/s
2
The specifi ed vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the specifi ed value
in exceptional circumstances.
The specifi ed vibration value can be used to
compare the equipment with other electric power
tools.
The specifi ed vibration value can be used for initi-
al assessment of a harmful eff ect.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Anl_PRO_OS_280_E_SPK7_Teil1.indb 14 Anl_PRO_OS_280_E_SPK7_Teil1.indb 14
GB
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
2. Damage to hearing if no suitable ear protec-
3. Health damage caused by hand-arm vib-

5. Before starting the equipment

= 9.521 m/s
2
h
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
5.1 Installing the dust collector
•
•
•
5.2 Installing the dust extractor adapter
Connect the dust extractor adapter (9) to the dust
extractor connector (a) as shown in Fig. 4 and
secure it by turning it. Connect the dust extractor
adapter to a suitable dust extraction system.
Caution!
The use of the dust collector or a dust extraction
system is absolutely essential for safety reasons.
- 14 -
mask is used.
tion is used.
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
(Figure 2-3/Item 6)
The dust collector (6) must be connected to
the dust extractor connector (a).
The dust is extracted directly through the grin-
ding/sanding paper and the orbital disk and
into the dust collector.
To empty the duct collector, open it as shown
in Fig. 3 and carefully tap it to remove the de-
bris.
(Figure 4/Item 9)
26.02.14 16:13 26.02.14 16:13